There are no products listed under this category.
Get the widest range of go kart steering hardware at OMB Warehouse, reliable and rugged and sourced from top manufacturers across the world.Go kart steering can be complex, overwhelming, and a source of major problems if not fitted to the go kart correctly. The go kart steering hardware comes as a part of the whole kit. It consists of 10 inch go kart steering wheel, 3/8 inch x 8″ tie rod with tie rod ends, 3/8 inch x 18″ tie rod with tie rod ends, (2x) 3″ tall spindle brackets with 1/2″ kingpin holes, RH & LH (right and left hand) spindles, Kill switch (it mounts to the steering hoop). All these components are OEM replacement parts of go kart steering hardware. The steering column has 11ga. 18″x3/4″ OD tubing for the steering shaft, Steering wheel hub made from a 2 1/2″ OD flat washer, and (2x) 3/4″ID (1″OD) bushings to hold the steering shaft in place under the steering hoop as well as against the lower bracket. Further, the Lower Bracket, Steering Stop & Pitman Arm has 3/16″ plate as the lower bracket and pitman arm, and 1″x1″x1/8″ thick angle iron for the steering stop.