SPECIAL ORDER
Zoom the image with the mouse
ARC Racing
ARC Flywheel Puller
PART NUMBER:
429351
Availability:
Ships same day if ordered before 12PM Eastern time.
In Stock Today:
43
Ships in:
Ships Today
$23.99
This flywheel puller is designed for those who don't want to use the "knocker" method to remove their flywheel.
Works with:
- ALL ARC Flywheels with Steel Adjustable Timing Hubs
- PVL Clone flywheel
- Raceseng Flywheels
To use, install the threaded rods into clean and lubricated puller holes on hub or flywheel face. Be sure to thread the rods in fully. Slide the puller block over the threaded rods and screw the nuts down evenly. Tighten the nuts evenly back and forth in 1/2 turn increments until the flywheel pulls off. Stubborn flywheels may require that you hit the center of the puller block with a hammer once significant pressure is applied by tightening the nuts. Be careful not to strike the threaded rods (use a spacer if necessary) and NEVER hit the flywheel itself with a hammer.
Heat as low as 300 ° will damage the rare-earth magnet in flywheels, so don't use a torch!
ARC is not responsible for any damage you cause to any flywheel removed with this tool, so be careful!
ARC Flywheel Puller
$23.99
This flywheel puller is designed for those who don't want to use the "knocker" method to remove their flywheel.
Works with:
- ALL ARC Flywheels with Steel Adjustable Timing Hubs
- PVL Clone flywheel
- Raceseng Flywheels
To use, install the threaded rods into clean and lubricated puller holes on hub or flywheel face. Be sure to thread the rods in fully. Slide the puller block over the threaded rods and screw the nuts down evenly. Tighten the nuts evenly back and forth in 1/2 turn increments until the flywheel pulls off. Stubborn flywheels may require that you hit the center of the puller block with a hammer once significant pressure is applied by tightening the nuts. Be careful not to strike the threaded rods (use a spacer if necessary) and NEVER hit the flywheel itself with a hammer.
Heat as low as 300 ° will damage the rare-earth magnet in flywheels, so don't use a torch!
ARC is not responsible for any damage you cause to any flywheel removed with this tool, so be careful!
